|
|
 Rank: Amateur level 2 Groups: Registered
Joined: 10/12/2013 Posts: 46 Points: 144 Location: London
|
Hello, I have just finished the differential on my RB7, but I'm a little concerned about the movement it has on one of the output shafts. One side is tight against the gears but the other has a few mm of movement. Also you can feel the gears as you turn the shaft properly. Its smooth but you can feel them. I've never built one or had a differential before so I just wanted to ask on here about it. It might just be normal lol Here's a bad quality video showing the movement. 
|
|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Movement on both sides should be about the same, though as its unused it will feel a little tight. Have you disassembled?
|
|
|
Rank: Amateur level 2 Groups: Registered
Joined: 10/12/2013 Posts: 46 Points: 144 Location: London
|
Tomick wrote:Movement on both sides should be about the same, though as its unused it will feel a little tight. Have you disassembled? Yes I took it apart and cleaned out the grease then reassembled, but its exactly the same. Have you watched the video ? Does it look ok ?
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
