|
|
 Rank: Beginner Level 2  Groups: Registered
Joined: 01/05/2013 Posts: 17 Points: 41 Location: Brisbane, AUSTRALIA
|
Hi All
I was Halfway through breaking in my engine when the starter cord snapped so I removed the engine to install a new Pull Starter, I have decided not to put the engine back in at this stage as i will have to pull it out again to install the Gearbox upgrade. (Completed Issue 100)
Is there anything I need to do to the half run in engine while it is off the Car apart from clog carb intake etc.
Will the engine be affected by only being half run in??
Thanks Guys any input would be appreciated.
|
|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Loosen the glowplug, then apply a few drops of after-run oil into the cylinder, manually turn the flywheel a few times to coat the internals then leave so that the piston is at its bottom dead centre, also remove any fuel from the tank.
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
