|
|
 Rank: Beginner Level 2  Groups: Registered
Joined: 29/06/2015 Posts: 15 Points: 35 Location: Reading, MA
|
I've been watching a lot of the Youtube build series for Deagostini Falcon build, and just received my first set of issues.
It seems like a lot of you are drilling holes in the ends of the turret cannons.
So...I assume you are doing this with a dremel or power drill.
Can someone give me a bit more detail...are you putting the cannons in a vise, what size drill bit, etc.
I'm a bit nervous about messing mine up by doing it wrong, but like the look.
Dan
|
|
|
 Rank: Super-Elite      Groups: Registered
Joined: 27/01/2014 Posts: 5,060 Points: 14,980
|
Arcadedl wrote:I've been watching a lot of the Youtube build series for Deagostini Falcon build, and just received my first set of issues.
It seems like a lot of you are drilling holes in the ends of the turret cannons.
So...I assume you are doing this with a dremel or power drill.
Can someone give me a bit more detail...are you putting the cannons in a vise, what size drill bit, etc.
I'm a bit nervous about messing mine up by doing it wrong, but like the look.
Dan Hi Dan and welcome to the forum To drill the cannon ends I used the point of a sharp scalpel to make a small indentation where the drill piece will go, this used form the drill bit end to sit in otherwise it will be quite difficult to hold it in place. I the used a pin vice drill and with a small bit gradually going up in bit size until I got the desired effect 
|
|
|
 Rank: Amateur level 2  Groups: Registered
Joined: 04/06/2015 Posts: 45 Points: 128 Location: Yakima
|
any drill can do that. I didn't drill mine out kept it the same. End of Line.
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
