|
 Rank: Vice-Master     Groups: Registered
Joined: 19/03/2010 Posts: 602 Points: 1,679 Location: Lincs
|
Okay I have started planking the hull of the Victory and have made some mistakes in doing so. I am posting this so that hopefully others won't do the same  I am building the version with the cut-out and painting the ship in the Black and Yellow Ochre scheme. a) DON'T plank from the rear upto the cut-out and then continue from the cut-out to the front of the ship. Alighning for the flow of the hull doing this is a nightmare. Instead plank OVER the cut out section and the entrance section and CAREFULLY cut the plank to make the cut out once the glue for EACH plank has dried fully. b) DON'T use the supplied plank bender. If you go slightly too far through the plank it will snap or create an "elbow" in the wood. This will cause major problems in sanding the hull smooth requiring a lot of filling. Not too bad if you are painting the hull but if going for the natural finish it will look awful! Use either a steam bender, just steam, or what works best for me is soaking the planks in warm water for a couple of hours. c) Take your time and ensure that you also glue along the full length of each plank. If you fail to do so, when you cut the gun ports a section of planking is likly to spring out from the hull. d) if you push a pin in too far then carefully using the edge of your craft knife lift the head away from the plank just enough so that you can grip it with your pliers. DON'T gough at the wood as this too will require filling. e) Constantly check the alignment of the planks from the left and right side of the hull. It is easy to make one side higher than the other. f) Remove all traces of glue as you go. If you leave a "bobble" of glue on the wood to dry it will be harder than the surrounding wood. Sanding it off will create a low spot in the surrounding area whihch will show once you add the final finish. Hope I am not preaching to the converted but I have made some of these mistakes my self and would like to prevent others from doing the same. You do not need a parachute to skydive. You only need a parachute to skydive twice.
Built: Golden Star, English Brig. RMS Titanic. (Academy 1/400 Centenary Anniversary Edition) Revell-Monogram 1/48 B-29 Superfortress 1:8 Baron von Richthofen's Fokker Tri-plane. HMS Victory. Nelsons Flag Ship. Sultan Arab Dhow. Artesania Latina Carmen II. The Battleship Yamato. Model Airways Wright Flyer 1:16 Scale. Trumpeter Bismarck 1/200. HMS Sovereign of the Seas. The Black Pearl.
Building:HMS Surprisel. Hatchette U96. Soleil Royal.
|
|
 Rank: Amateur level 2  Groups: Registered
Joined: 08/04/2010 Posts: 46 Points: 156 Location: Andover
|
Thanks for that riff-raff will take heed forewarned is forearmed. Malcolm Only got room for one build, but might try and sneek in a small one later Have snuck in the Endevour
|
|
 Rank: Pro  Groups: Registered
Joined: 28/03/2010 Posts: 152 Points: 513 Location: Liverpool,England
|
Thanks Riff Raff. Useful info/warnings. I am intending to use aliphatic resin glue to do the planks. Do you think this would do the job ? Jimmy L.
current builds : Lancaster 1/32 (Hachette) Revell USS Kearsarge Titanic Lifeboat
I started off with nothing and I've still got most of it left.
|
|
 Rank: Vice-Master     Groups: Registered
Joined: 19/03/2010 Posts: 602 Points: 1,679 Location: Lincs
|
Not to sure about the resin as I have never used it - I like the good old PVA. easy to clean off and you can water it down if needed. I have heard of many here who do use it though. You do not need a parachute to skydive. You only need a parachute to skydive twice.
Built: Golden Star, English Brig. RMS Titanic. (Academy 1/400 Centenary Anniversary Edition) Revell-Monogram 1/48 B-29 Superfortress 1:8 Baron von Richthofen's Fokker Tri-plane. HMS Victory. Nelsons Flag Ship. Sultan Arab Dhow. Artesania Latina Carmen II. The Battleship Yamato. Model Airways Wright Flyer 1:16 Scale. Trumpeter Bismarck 1/200. HMS Sovereign of the Seas. The Black Pearl.
Building:HMS Surprisel. Hatchette U96. Soleil Royal.
|
|
 Rank: Beginner Level 1 Groups: Registered
Joined: 16/07/2010 Posts: 5 Points: 15 Location: England
|
Cheers Riff Raff, great advice for us newbie's, cheers mate.
|
|
 Rank: Super-Elite      Groups: Registered
Joined: 24/04/2010 Posts: 5,787 Points: 17,662 Location: Stafford, United Kingdom
|
Hi AXL Aliphatic is great, that is what I have used so far,it wipes of easily, and if you have not removed It all when it is dry you can sand it no problem Cheers MWG MWG BUILD DIARIES: HMS VICTORY, SOVEREIGN OF THE SEAS, SAN FRANCISCO II, HMS HOOD, HMS ENDEAVOUR LONGBOAT, HMS VICTORY X-SECTION, 007 DB5, NISSAN GTR, CUTTY SARK, RB7, AKAGI, BARK HMS ENDEAVOUR, HUMMER H1, MITSUBISHI ZERO.
|
|
 Rank: Super-Elite        Groups: Registered
Joined: 04/04/2010 Posts: 3,955 Points: 11,809 Location: uk
|
riff-raff,a couple of things here,first,well done for pointing out some of the pitfalls,but the plank bender is kosher,if you know how to use it,the bit you were talking about is for cutting,you turn the blade around with pliers and then you can use it for bending planks.nobody has twigged it as yet.some even drill a hole in the handle and use a blunted screw to adjust the depth of the cut.which ever takess your fancy. and aliphatic glue has 3 times the grab of pva woodglue,again it is personal choice. Current builds: SotS, USS Consitution, San Felipe, D51 loco, HMS Surprise, RB7, Arab Dhow, Jotika HMS Victory Completed builds: HMS Pickel, Thermopylae, Mississipi river boat, Mary Rose, Cutty Sark, San Francisco II, HMS Victory x5, Titanic Lifeboat, Panart HMS Victory Launch, Hachette Titanic, Virginia Schooner, Endeavour Longboat. http://www.model-space.com/gb/
|
|
 Rank: Vice-Master     Groups: Registered
Joined: 19/03/2010 Posts: 602 Points: 1,679 Location: Lincs
|
Thanks for the info - it never crossed my mind to try to turn the blade around but having look closer at the plank bender I can see what you mean. Thanks Riff-Raff You do not need a parachute to skydive. You only need a parachute to skydive twice.
Built: Golden Star, English Brig. RMS Titanic. (Academy 1/400 Centenary Anniversary Edition) Revell-Monogram 1/48 B-29 Superfortress 1:8 Baron von Richthofen's Fokker Tri-plane. HMS Victory. Nelsons Flag Ship. Sultan Arab Dhow. Artesania Latina Carmen II. The Battleship Yamato. Model Airways Wright Flyer 1:16 Scale. Trumpeter Bismarck 1/200. HMS Sovereign of the Seas. The Black Pearl.
Building:HMS Surprisel. Hatchette U96. Soleil Royal.
|
|
Guest
|