|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
In issue 10 we were given a mast holder. No reference has been made to its insertion into the model. There is a gap in the keel which I think is it's home but now the lower and middle gun decks are in position, I can't fix it. Is this an ommission in the instructions? If so, any ideas on what I can now do?
|
|
|
 Rank: Vice-Master  Groups: Registered
Joined: 20/04/2010 Posts: 545 Points: 1,536 Location: lossiemouth
|
its just for linning up the bottom of the mast port and stabouard realy needed if only one deck but with 2 or three decks the deck holes will line up the mast just cut it and fit it if you want to
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Not sure why we have the same question running across two topics, but if you refer to step 3 of issue 16, it tells you to locate all frames into the false keel, the mast support frame part 6) is shown in place at step 5 on page 12.
Cut the part in half top to bottom, then glue and insert the halves from either side underneath the lower gun deck.
|
|
|
Rank: Pro  Groups: Registered
Joined: 20/03/2010 Posts: 278 Points: 833 Location: Nottingham
|
drake wrote:In issue 10 we were given a mast holder. No reference has been made to its insertion into the model. There is a gap in the keel which I think is it's home but now the lower and middle gun decks are in position, I can't fix it. Is this an ommission in the instructions? If so, any ideas on what I can now do? Thanks for the heads up on this matey I had completly forgotten about it.  Pam's shipyard is closed for now no more room!
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
