|
|
 Rank: Pro    Groups: Registered
Joined: 03/02/2015 Posts: 457 Points: 1,389 Location: Crawley, W.Sx, UK
|
Hello Please see attached photo. Fuselage plate 86 in place dry, and plate 116 held up against plate 86 and there are gaps. The part of the bent plate is slightly curved where it butts up against the centre plate, however the centre plate is straight? Any ideas? Thank you. Regards Alan
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Your jumping ahead without having fitted nose side plates. You need to add the plates in the same sequesnce at the instructions, otherwise your going to have all sorts of problems!
Initially it looks like you have the plate the wrong way round, the curved edge should be at the bottom and its straight edge at the top so that it butts to the straight edge of the top plate.
Tomick attached the following image(s):
|
|
|
Rank: Pro Groups: Registered
Joined: 03/02/2015 Posts: 457 Points: 1,389 Location: Crawley, W.Sx, UK
|
Hi
Thank you. I seem to be having an issue with these plates! Need to slow down a bit.
Regards
Alan
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
You will if you dont fit them in sequence with instructions.
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
