|
|
 Rank: Amateur level 2  Groups: Registered
Joined: 24/05/2015 Posts: 43 Points: 109 Location: Adelaide
|
Trev,looking at your tail area your elevators, did u have to take a few mills off the elevators to fit, looking, at your markings on the plates near the rudder end it is same as mine after I had to take off about 4mil. max
|
|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
To save your question being missed, you should place this post as a question in trevs build diary in reply to the relevant post on this
|
|
|
 Rank: Elite     Groups: Registered
Joined: 13/02/2011 Posts: 2,239 Points: 6,837 Location: East Sussex
|
Hi Max001, Apologies for the delay, in answer to your question regarding the elevators, yes I did have to make small adjustments to each side to ensure of a good fit, this is as all builds are different, then after checking the fit I rivet marked them. Regards Trev. Work in progress: Tombstone (Scratch) - San Francisco 2. -The Mayflower ( scratch by plan).
OcCre- Santa-Maria (Kit).
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
