First of all my apologies for not responding to this subject sooner but being halfway through a move and no internet etc I have been unable to respond until now. ( I am currently in my loft with my iPad as it's the only way I can get 4G so if the conversation drops mid sentence then I've fallen through the rafters!)

Below is a list of all the wires and hoses used throughout the series up to Pack 19

I have gone through the list and changed some of the details to make this simpler to understand and the official build will be updated in due course.

Stage 30 contains:
Hose A (1.2mm X 750mm)
Wire A (0.4mm X 800mm)

Stage 40 contains:
Silver Braided hose B (1.4mm X 700mm)

Stage 49 contains:
Hose C (1.7mm X 150mm)

Stage 63 contains:
Wire B (1) 0.56mm X 300mm)
Wire C (2) 0.8mm X 600mm)
Wire A (3) 0.9mm X 300mm)

Stage 66 contains:
Wire E (1.0mm X 400mm)
Clear Nylon Tube (0.9mm X 130mm)

In stage 66 of the electrical system there is a mention of "Wire D". This is in fact "Wire A" provided with stage 63 and is a typo and something I overlooked so my sincere apologies as this should have been corrected at the time.

As to the lengths of the wires for the telemetry system in step 3 of page 526
Wire "C" is 600mm long and the lengths to be cut are:
2 X 50mm lengths
1 X 75mm length
1 X 65mm length
Also the wire "C" for the engine block is 70mm long
Total length used = 310mm

Step 4 electrical system on page 527:

Part "A" electrical system:
2 X 25mm lengths and 1 X 220mm length from wire "B" total length used = 270mm

Part "B" Electrical system:
Cut 2 X 45mm and 2 X 76mm lengths of wire "A" total length used = 242mm


Can I ask anyone that has a problem in future (let's hope there isn't any) that you pm me with your query so that I may offer a resolution faster. There are times as like my current situation that I am not always able to respond on the forum as wished for but a PM to me will allow me to assist you sooner as I will be more than happy to even talk through any problems over the phone.

If anyone has an issue regarding the above info I have provided then please once again, pm me first please.

Regards

Spencer

Hello

I'm afraid I DID assume that 1=A, 2=B, and 3= C. So I have used the wrong wire, Wire 3/A, for the wires connected to the telemetry unit. I twigged when I ran out of wire, and then saw the mysterious wire D in the next stage.

I accept it is my own silly fault for not checking here first, but it seemed to be logical that would be the case!! Also looking at the pictures they seemed to match that scenario.

So does anyone have any spare wire from this stage or can you point me in the direction of replacements/substitutions? I don't really want to re-order a whole pack for the sake of a few bits of wire....

Thank you very much Tomick. Next time I'll come here before I start cutting wires up!!