Welcome Guest Search | Active Topics | Log In | Register

Wire Cutter, guillotine Options
Previous Topic · Next Topic
jase
#1 Posted : 18 March 2017 19:44:17

Rank: Super-Elite

Publisher Medal: Featured Build of the MonthActive Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsTurquoise Medal: Turquoise Medal for model making know-how contributionOutstanding Build: An award for an outstanding buildBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Registered

Joined: 21/03/2010
Posts: 7,582
Points: 21,739
I have been giving this tool a bit of a bash recently, its an excellent tool if you have a lot of repetitive brass or plastic rod to cut at the same length. The tool cuts from 0.0mm to 1.50mm and the guillotine cuts striaght with no pinching so no needful filing off ends to square them up. There is a length stop to allow repeat cuts of the same length, its relatively cheap too but very good quality.

http://www.proopsbrother...0-15mm-j1002-1428-p.asp



“Whenever you find yourself on the side of the majority, it is time to pause and reflect.”
-Mark Twain
Back to top
 Report Abusive | Report SPAM
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.084 seconds.
DeAgostini