|
|
 Rank: Newbie Groups: Registered
Joined: 26/05/2018 Posts: 3 Points: 9
|
I did not follow the instructions, of course, but on the Transom there are 4 notches that I should have cut away the planking strips. I covered them with the walnut strips and I am unable to locate them now. Could someone please send me the measurements of the locations, If possible I will measure from the top of the stern gun port edge up to the notches. Thank you in advance for any help, Frank frank1964 attached the following image(s):
|
|
|
 Rank: Super-Elite        Groups: Registered
Joined: 11/11/2009 Posts: 3,432 Points: 10,280 Location: Bâe Colwyn, Wales
|
If you measure down from the top of the radius down, the measurements are to the top of each notch.
Hope this helps you, and good luck with the rest of your build.
Chrismagpie1832 attached the following image(s): On the bench 1/350 Revell Tirpitz Platinum Edition (Pontos PE and Wooden deck) plus extra Eduard PE set and extra MK1 door sets.
|
|
|
Rank: Newbie Groups: Registered
Joined: 26/05/2018 Posts: 3 Points: 9
|
Yes, that helped a great deal chris. Thank you for taking the time to answer.
Frank
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
