Welcome Guest Search | Active Topics | Log In | Register

marking and cutting out the port holes Options
ronald305
#1 Posted : 12 September 2018 15:35:30

Rank: Pro

Groups: Registered

Joined: 08/02/2015
Posts: 426
Points: 1,259
Location: Louisiana
Hi there
this question about marking and cutting out the first set of gun port holes I would like to know should I wait till the whole ship is ready for sanding and filling or can I sand the 12 planks to make it easy to mark the port hole for cutting out or is ok the mark them as is uneven then sand and fill the nicks and dents when the all planks done thank you
Ronald
z8000783
#2 Posted : 12 September 2018 15:39:13

Rank: Elite
Active Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsBuild-Diary Medal: Build-Diary Medal of Honour
Groups: Unapproved

Joined: 24/05/2010
Posts: 1,761
Points: 5,351
Location: London & Greece
Ronald, You need to do them before you sand as there are some side and top supports to fit as well. You can cut them out a row at a time or wait, it's up to you but the unsanded finish should be fine to work with.

This wood is so very light you will always need to be careful about over sanding, so wait until all the planking is finished.

ronald305
#3 Posted : 12 September 2018 18:07:44

Rank: Pro

Groups: Registered

Joined: 08/02/2015
Posts: 426
Points: 1,259
Location: Louisiana
OK that's all I need to know thanks John
Ronald
Gandale
#4 Posted : 12 September 2018 22:46:23

Rank: Super-Elite

Publisher Medal: Featured Build of the MonthActive Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsTurquoise Medal: Turquoise Medal for model making know-how contributionOutstanding Build: An award for an outstanding buildBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Registered, Global Forum Support, Moderator, Official Builds, Administrators

Joined: 08/09/2012
Posts: 15,172
Points: 46,151
Location: Aberdeen
Hi Ronald, I would recommend you follow the instructions and sand the hull when instructed to do so. Marking out the gun port positions on the hull prior to sanding shouldn't present you with any problems.....

Regards

Alan
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.085 seconds.
DeAgostini