|
|
 Rank: Newbie Groups: Registered
Joined: 18/11/2018 Posts: 2 Points: 6 Location: Folkestone
|
In Issue 96, the instructions state to use 12mm screws when fitting the drive motor case. I don't have any of this size somehow so although I can get them online, there seems to be a 'M'code which I assume is a sizing thing?
Can anyone help me please with which M 12mm screws I should be ordering?
Thanks
|
|
|
 Rank: Beginner Level 3 Groups: Registered
Joined: 18/11/2018 Posts: 21 Points: 63
|
Hi! In the official build diary it says that's mistake in the magazine, here's what you need to use ☺
Note
The instructions on page 14, stage 13 tell you to use 3 x 12mm screws to attach the bearing housing. The correct screws to be used are the 2 x 6mm screws provided in stage 94.
|
|
|
Rank: Newbie Groups: Registered
Joined: 18/11/2018 Posts: 2 Points: 6 Location: Folkestone
|
Magical Barrie wrote:Hi! In the official build diary it says that's mistake in the magazine, here's what you need to use ☺
Note
The instructions on page 14, stage 13 tell you to use 3 x 12mm screws to attach the bearing housing. The correct screws to be used are the 2 x 6mm screws provided in stage 94.
Thank you. I shall try 6mm screws later.
|
|
|
|
Guest (2)
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
