|
|
 Rank: Newbie Groups: Registered
Joined: 26/09/2018 Posts: 3 Points: 9 Location: Glasgow
|
Hi anyone else have a similar problem I've completed the model but the lightsabre eject mechanism only opens it won't close. The connections seem to be good (it worked at the test stage) and I removed the unit and opened it up to make sure that nothing was catching but it still persists. Only thging I did notice was a slight grinding sound after rdd2 boots up don't know if this is normal or it's the nylon gears in the tube.
Any suggestions gratefully received
|
|
|
|
|
You might want to check the gears run smooth and that they have not misaligned. Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Newbie Groups: Registered
Joined: 26/09/2018 Posts: 3 Points: 9 Location: Glasgow
|
Hi thanks for responding.
I did think that but it looked ok when I opened it up and put the base back to the bottom of the tube. It ejects ok but won't retract and I've checked it's not obstructed.
|
|
|
|
|
Hi are the micro switches working and is it traveling all the way to hit the upper micro switch Current builds:-C57,Zero, Lamborghini Countach, Caldercraft HMS Agamemnon,Robi,R2-D2, MFH Cobra .
|
|
|
Rank: Newbie Groups: Registered
Joined: 26/09/2018 Posts: 3 Points: 9 Location: Glasgow
|
I assume that they are as I tested it as per issue 53 and it worked fine then.
Can't test it again as the test cables were installed when it was complete.
|
|
|
|
|
Order a replacement motor from C/S Current builds:-C57,Zero, Lamborghini Countach, Caldercraft HMS Agamemnon,Robi,R2-D2, MFH Cobra .
|
|
|
|
Guest
|
US
