Welcome Guest Search | Active Topics | Log In | Register

Rossi Build lower cross-member Options
CaptnBirdseye
#1 Posted : 11 March 2020 20:47:02

Rank: Superelite

Active Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Registered

Joined: 10/05/2010
Posts: 2,608
Points: 7,519
Location: Lincolnshire
Confused Not really a moan as such, but just wondered if anyone else has had issues when fitting the lower cross-member from Pack 11, Stage 42?

The only reason i ask is that, on mine, the threaded holes are not threaded fully to the end, only half way. This means that the supplied screws sit way proud when attached to the engine. If you see the attached photos, you will see what i mean.

Regards
Gray
CaptnBirdseye attached the following image(s):
1Q4A0523.jpg
1Q4A0524.jpg
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.083 seconds.
DeAgostini