Hi DaDokta, thank you for dropping in on my build.

And the ladies strong box, I went a slightly different way.







The lock didn't come with the kit it was something I found online there will be two side handle but they haven't arrived yet.

Some very nice skilful work.

Mark

Done some more today, still glueing the outer strips so nothing to really show.

But I did manage to look at my electronics for the lights

I didn't like the idea of a switch inside the compartment and because this will be inside a case when finished I needed something that was particle so remote control

Lights on



Lights off

Very nice work.

Mark

Cheers all for dropping in.

Handles arrived so the strong box is all finished.

So onto the frame work.



The top sections are easy just remember to shape the edges from outside to inside. The lower sections need to curve so I cut them to the size I needed and then placed them in some hot/kettle water so I could shape them.



Wedged them in and will glue them tomorrow, the instructions tell you to install all the frame work then sand them all down so they sit about 1mm on the outside, I personally find it easier to do each one at a time.

So I glued in the four top window frames and then got them to the correct width and I'll do the same with the lower ones, this will also make it easier to install the side frames as you can line them up to the upper and lower frames.

Great work

This is looking really great!