|
|
Rank: Administration        Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,282 Points: 23,934 Location: East midlands
|
Hi All, back again with some more Infinity Gauntlet. 
This is Pack 3 that will cover issues 7 to 11
This update is for issue 7, that continues the work on the palm of the Gauntlet.
Parts supplied are as always shown in Pic 1.
Position the smaller part supplied (A96)into its position on the main palm piece from Issue 6 as shown in Pic 2. Then whilst holding the parts together, turn them over and secure the part with 2 of the supplied screws. Pic 3.
That completes this update with the finished assembly and part A95 (to be used later) in Pic 4.
Be back soon with the update for issue 8.
Regards
delboy271155
(Derek) Admindelboy271155 attached the following image(s): COME BACK GUY FAWKES "YOUR COUNTRY NEEDS YOU"
|
|
|
Rank: Administration Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,282 Points: 23,934 Location: East midlands
|
|
|
|
Rank: Administration Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,282 Points: 23,934 Location: East midlands
|
Well, this is going well.
Welcome back for the next update. (Issue 9) Where we will extend the the back face of the Gauntlet.
During this issue I came across a problem the the fit of the parts. This was looked into and a cure found, so I will explain what happened during this update, but I must stipulate that this may not be a problem for everyone. It could have been that I had a rouge moulding problem.
More on that in a bit, lets get on.
Parts supplied shown in Pic 1. All screws used in this update are of the same type as supplied with this issue.
The plate supplied (A34) fits on the lower right hand side of the Gauntlet rear assembly. Pic 2.
NOTE: this is where I had the problem with the fit of the parts. Having looked at all the points where the two parts came together I found a lug in the moulding, Pic 3. Now I don`t know, (as I`ve nothing to compare it too) whether this should even be there. That said, with the use of a micro file I removed just the tip of the lug and the fit of the parts were then perfect.
With the fit as it should be, the parts are held firmly together using 3 of the supplied screws. Tip: Whilst fitting these screws, remove them Gem Stones from their positions. You can then insert and tighten the screws without putting undue pressure on the stones and their switches. Pic 4.
That completes this issue. Pic 5. So I hope to see you all very soon for Issue 10`s update, where there will be another addition to the back of the Gauntlet.
Regards
delboy271155
(Derek) Admindelboy271155 attached the following image(s): COME BACK GUY FAWKES "YOUR COUNTRY NEEDS YOU"
|
|
|
Rank: Administration Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,282 Points: 23,934 Location: East midlands
|
|
|
|
Rank: Administration Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,282 Points: 23,934 Location: East midlands
|
|
|
|
|
Guest
|
US
