|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 4,422 Points: 13,423 Location: ipswich
|
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 4,422 Points: 13,423 Location: ipswich
|
On we go.
After some careful dismantling (breaking it apart) the bits were soaked overnight in oven cleaner and washed, then sanded.
Now in primer and the cockpit is silver and the seat black.
These bits will go back together shortly. roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 4,422 Points: 13,423 Location: ipswich
|
A little done.
Interior parts reassembled and the side pods are now attached to the body panels but only at the upper edge so far.
The pods are incredibly warped so I've fixed the upper edge leaving the bottoms free.
When the glue is fully set - 24 hours?
I'll pull the lower edges in and clamp them, with some glue in the join.roymattblack attached the following image(s):
|
|
|
Rank: Administration   Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,226 Points: 23,766 Location: East midlands
|
Hi Roy,  You certainly know how to pick em.  I`m sure it will end up very presentable in your hands. Good Luck. Regards delboy271155 (Derek) Admin COME BACK GUY FAWKES "YOUR COUNTRY NEEDS YOU"
|
|
|
 Rank: Pro Groups: Registered
Joined: 25/02/2017 Posts: 331 Points: 992 Location: surrey
|
Another one to test your patients. I’m sure you get through and have a decent model in the end. Andy.
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 4,422 Points: 13,423 Location: ipswich
|
Many thanks you chaps.
All good fun.
I've fixed the rear side pods into place now and the body sides are glued at the bottom edge.
I've built enough of these kits now to know the (numerous) pitfalls - one being that when the body tub is assembled, the front frame won't fit.
I'll put the front frame in place when the body lower joins are set, then 'wrap' the body sides around it and then add the upper front deck.
When all is dry, take the frame out again, knowing it will fit later on.
Front frame now mostly sorted and pipework added to it.roymattblack attached the following image(s):
|
|
|
|
|
The amount you’ve done of these type of kits Roy, you ought to start your own repair shop program. 
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 4,422 Points: 13,423 Location: ipswich
|
Not a bad idea Mark. lol.
The body primer has hardened off for a good few days so now it's been masked and had 3 coats of gloss white.
Masking off tomorrow. roymattblack attached the following image(s):
|
|
|
|
Guest (3)
|
US
