Rank: Administration        Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,421 Points: 24,354 Location: East midlands
|
Hi All 
Well its been a long time since Pack 1 landed, but here we are with Pack 2. This pack will cover issues 3 - 5.
Issue 3 - Part A.
Parts supplied.....Pic 1.
NOTE: Before you build anything, test the LED circuit board 19, using the test parts from Issue 2. See Pic 2.
Start with the thumb, part 01 and position the joint 17L so the tab engages with the thumb and fix them together with a type A screw, Pic 3. Then press fit the second thumb part 02 over the joint as in Pic 4. Now construct (press fit) the four fingers of the left hand as shown in Pic 5.
Bring the palm side of the hand 13L to the table and position the thumb , fixing it with a type A screw, Pic 6. Next, place the Index finger and fix that with a type A screw also, Pic 7. Repeat this last operation with the Middle and Little fingers, fixing both with type A screws, Pic 8. DO NOT fit the Ring finger at this time.
Working on the inside of the palm, add the palm screen 14L using the orientation in Pic 9. Then add the Screen Holder 16 and fix the parts using 2 x type B screws, indicated in Pic 10. Finally for this part of Issue 3, add the LED board 19 that you tested earlier and fix its position with a type B screw. Shown in Pic 11.
See you soon for Issue 3, Part 2.
Regards
delboy271155
(Derek)delboy271155 attached the following image(s): COME BACK GUY FAWKES "YOUR COUNTRY NEEDS YOU"
|
Rank: Administration Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 8,421 Points: 24,354 Location: East midlands
|
Hi All, "I`m back"
Issue 3, Part B.
Picking up from Part A, position the Ring finger onto the palm 12L, as in Pic 12. Then bring the previous assembly to the table and feed its wired plug through the back of the hand as indicated (yellow arrow) in Pic 13. Now bring the two halves of the hand together, keeping the Ring finger in place and not trapping the wire. Pic 14. With everything in its place, fix the parts together with a type C srew as in Pic 15. Now cover the last screw with the palm cover plate 11L, Pic 16. A second securing screw, type B, is placed near the wrist as shown in Pic 17.
Finally press the Web launcher frame 15L into position, Pic 18. A final test of the LED if you want, Pic 19 and the final assembly with the unused part 18, which needs to be kept safely for later use in Pic 20.
That`s all for Issue 3. 
Regards
delboy271155
(Derek)delboy271155 attached the following image(s): COME BACK GUY FAWKES "YOUR COUNTRY NEEDS YOU"
|
US
