|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 6,815 Points: 20,762 Location: Northamptonshire, England
|
Issue 6
Picture 1 shows the contents of this issue.
Toe of the Left Shoe
Place the left horn (6B) and right horn (6C) and place them on the holes in the top of the Toe (6A), picture 2. Turn the assembly over and secure them in place using 2 x EP screws, picture 3.
Place the toe assembly on the left shoe from issue 5, picture 4. Turn the assembly over and secure the toe in place using 2 x FB screws, picture 5.
That completes the assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 6,815 Points: 20,762 Location: Northamptonshire, England
|
Issue 7
Picture 1 shows the contents of this issue.
The Left Ankle
Insert the pointed part of the locking bolt (7B) into the base of the ankle joint (7A), pictures 2 and 3. Add the spring (7C) as shown in picture 4.
Fit the ankle locking plate (7D) onto the base on the ankle and secure with 2 x BM screws, picture 5.
Finally, attach the assembly to the inside of the show assembly from the previous issue and secure it in place using 2 x EM screws, picture 6.
Picture 7 shows the assembly complete for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 6,815 Points: 20,762 Location: Northamptonshire, England
|
Issue 8
Picture 1 shows the contents of this issue.
The Left Shoe Sole
Retrieve the assembled left shoe and turn it over and place the shoe sole (8A) on the bottom securing it using 2 x FM screws, picture 2.
Place the four retention discs on each side of the ankle joint as shown in picture 3.
That completes the assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest
|
US
