Welcome Guest Search | Active Topics | Log In | Register

Peugeot 205 Dakar Turbo Official Build STAGES 39 - 44 Options
roymattblack
#1 Posted : 18 October 2025 13:47:45

Rank: Super-Elite

Publisher Medal: Featured Build of the MonthActive Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsOutstanding Build: An award for an outstanding buildBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered

Joined: 04/06/2011
Posts: 5,065
Points: 15,341
Location: ipswich
STAGE 39A:

Left front transmission.

Pic 1: Locate the stub axle parts 39A and 39B and fit them together as shown
.
Pic 2: Retrieve the shaft 8D saved from stage 8 and fit it through the gaiter 39C and then the plate 39D.

Pic 3: Shows the parts fitted together.

Pic 4: Fit the assembly to parts 39A/B and fix together with 4 x AM screws.

Pic 5: Fit the wheel guard 39G as shown and fix with 2 x AP screws.
roymattblack attached the following image(s):
PARTS.JPG
39 (1).JPG
39 (2).JPG
39 (3).JPG
39 (4).JPG
39 (5).JPG
roymattblack
#2 Posted : 18 October 2025 13:51:39

Rank: Super-Elite

Publisher Medal: Featured Build of the MonthActive Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsOutstanding Build: An award for an outstanding buildBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered

Joined: 04/06/2011
Posts: 5,065
Points: 15,341
Location: ipswich
STAGE 39B:

Pic 6: Press-fit the brake pipe connector 39F into the caliper 39E.
Make sure it is angled as shown.

Pic 7: Fix the caliper to the main assembly with 2 x AM screws.

Pic 8: Fit the narrow end of the upper arm 39H to the main assembly in the position shown and fix it with 1 x BM screw.

Pic 9: Fit the brake pipe 39J to the connector 39F.

Pic 10: Fit the support 39I to the assembly in the position shown and fix with 1 x ANM screw from the outside at each end.

Store the assembly safely for now.

roymattblack attached the following image(s):
39 (6).JPG
39 (7).JPG
39 (8).JPG
39 (9).JPG
39 (10).JPG
Users browsing this topic
Guest (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.118 seconds.
DeAgostini