|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,020 Points: 21,367 Location: Northamptonshire, England
|
Issue 27
Picture 1 shows the contents of this issue.
The Right Ankle
Place one of the spacers (27D) into both halves of the right ankle (27A & B), pictures 2, 3 and 4.
Retrieve the completed ankle joint from issue 25 and place its smooth circular end between the two discs of the left ankle (27C), picture 5. Secure the two parts using the hexagonal screw, two washers and the nut as shown in picture 6.
Finally, cover the assembly with the two halves of the ankle covers. Note the part 27C has a pin at the end, this goes into the half with the slot, pictures 7 and 8.
That completes the assembly for this issue.Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,020 Points: 21,367 Location: Northamptonshire, England
|
Issue 28
Picture 1 shows the contents of this issue.
The Right Calf
Retrieve the ankle assembly from the last issue. Place this in the narrowest part of the left calf (28A), picture 2. Secure it in place using a GM screw at the back of the ankle assembly and 2 x EM screws at the front, picture 3.
Picture 4 shows the complete assembly for this issue.Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,020 Points: 21,367 Location: Northamptonshire, England
|
Issue 29
Picture 1 shows the contents of this issue.
The Right Leg and Knee
Insert the locking piston (29C) into the joint housing (29A). Insert the spring (29D), pictures 2 and 3. Close the housing with the cover (29E) and secure it using 2 x HM screws, picture 4.
Position the gear (29B) on the joint, and align the hole and insert the pin in the two parts, pictures 5 and 6.
Place the joint assembly into the assembly from the previous issue, securing it in place using 3 x EM screws, picture 7.
Assemble the joint covers (29G and 29H) and secure them together using a JP screw, picture 8.
Place the cover over the joint in the housing and secure using 2 x JM screws to the front and a KM screw at the back, picture 9.
Picture 10 shows the complete assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest
|
US
