|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,041 Points: 21,430 Location: Northamptonshire, England
|
Issue 9
Picture 1 shows the parts for this issue.
Retrieve the engine assembly you’ve been working on and fit the cooling connector (9A) to its mounting location as illustrated in picture 2. Secure this in place using 4 x AP screws, picture 3.
Assemble the connector (9D) to the plate (9C) using an AP screw, pictures 4, 5 and 6. Now place the assembly on the engine block as shown in picture 7, securing in place using 4 x AP screws, picture 8.
Take the medium size pipe (9F) and push fit it in place as shown in picture 9. Place the coolant pump (9E) on the other end of the pipe, picture 10.
Push the shorter pipe (9G) onto the pin of the liquid coolant connector, picture 11. Now push fit the part (9B) on the other end of the shorter pipe, picture 12, followed the longer pipe onto the other end of the part, picture 13.
Picture 14 shows the complete assembly for this issue.Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest (3)
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
