|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,070 Points: 21,517 Location: Northamptonshire, England
|
Issue 57 Part 1
The Shoulder connectors and Right Leg
Take the left shoulder connector and place 4 x M3 nuts into the holes as shown in picture 2. Place the left connector cover over the nuts and into the shoulder connector and secure it in place using an E type screw, picture 3. Now take the right shoulder connector and place the last four M3 nuts as before, picture 4, then cover it with the right connector cover, securing it using an E type screw, picture 5.
Retrieve the torso assembled in issue 56 and fit the left shoulder connector into the shoulder socket, securing it in place using 4 x type G screws, picture 6. Do the same on the opposite side with the right shoulder cover, picture 7.
Next, we make the cardboard stand for the torso, picture 8. Fold the side panels as shown in picture 9, with the four tabs facing inwards, then fold the side in over the tabs, picture 10. Finally, push the tabs on the top inwards as illustrated in picture 11.
Picture 12 shows the assembly complete for part 1 of this issue.Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,070 Points: 21,517 Location: Northamptonshire, England
|
Issue 57 Part 2
Right Leg
Plug one of the ends of the cable into the coil connector, picture 13. Place the coil base into the sole of the right foot, picture 14, then place the coil connector into the base, picture 15. Position the cover so the slot goes over the cable, then secure it in place using 2 x type F screws, picture 16.
Fit the right heel gold trim onto the heel and fix the two parts together with 2 x type E screws, picture 17.
Finally fit the heel on the back of the sole and secure it in place using two more type E screws, picture 18.
Picture 19 shows the assembly complete for part 2 of this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,070 Points: 21,517 Location: Northamptonshire, England
|
Issue 58
The Right Leg
Picture 1 shows the parts for this issue.
Retrieve the right foot assembly from issue 57 and fit the foot mount inside, taking care not to trap the cable. Secure it in place with 2 x type P screws using the M4 allen key, picture 2.
Position the right foot post over the foot mount making sure the arrow, as shown in picture 3, is pointing upwards.
Fit the inner structure of the foot on the side of the post, picture 4. Fasten the foot structure with a type J screw, also picture 4. Finish securing the structure using two M3 hexagonal anti slip nuts, picture 5 and Type R screws on the other side, picture 6.
Finally, reinforce the joint by attaching a type J screw through the sole as shown in picture 7.
Picture 8 shows the assembly complete for part 1 of this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest
|
US
