|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,115 Points: 21,652 Location: Northamptonshire, England
|
Issue 21
Picture 1 shows the parts for this issue.
This issue is quite fiddly and will need a bit of patience when fitting the heat protection sheets.
You get four sheets for this process. I did mine using two sheets, but feel free to cover the part differently if you need more than the two, I used. I started at the back of the lower intake box and had the sheet to just one side, so it covered the top, front and back using the double-sided tape to stick the foil to the part, pictures 2,3 and 4.
I then used the second sheet in the same way, so it covered the opposite side, picture 5. Once you have covered the lower intake box, using a craft knife carefully cut away the excess and the two holes as shown in picture 6.
Retrieve the engine assembly and place the lower intake box between the head area, securing it in place using 6 x BP screws as illustrated in picture 7.
Picture 8 shows the assembly complete for this issue.Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
