|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,492 Points: 16,628 Location: ipswich
|
STAGE 81:
Front crossbar.
Pic 1: Slide the bracket 81F over the strap 81D.
Pic 2: Stick one of the self-adhesive tabs 81H to the end of the strap.
Pic 3: Remove the backing from the tab and fold the strap over the bracket as shown.
Pic 4: Repeat with the other bracket 81F at the other end of the strap.
Pic 5: Stick another tab 81H in the centre of the strap and position the hook 81G as shown.
Pic 6: Remove the backing and fold the strap in half, trapping the bracket in place.
Pic 7: Retrieve the main assembly and press-fit the two end brackets into the holes in the front floor where indicated.
Make sure the central hook on the strap is facing down.
Pic 8: Retrieve the spare wheel from the previous stage and fit it in place.
Secure it with the front strap just fitted, and the strap from the bulkhead just behind the spare wheel.
Pic 9: Assemble the crossbar 81A and end brackets 81C as shown and fix with 1 x AOM screw in each.
Pic 10: Fit the assembly into the front of the car as shown and fix with 2 x AM screws.
Pic 11: Fit the covers 81E and 81B in place and fix from underneath with 2 x AM screws in each.
NOTE: This is extremely fiddly as access to the fixing holes is very limited.
You may be advised to glue the covers in place before turning the model over to fit the screws.
This is at the builder’s discretion.
Store the model safely for now.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,492 Points: 16,628 Location: ipswich
|
STAGE 82:
Tinted window.
Pic 1: This stage gives you the option to fit tinted windows.
This is at your discretion.
The clear windows will be kept in this build so the interior is easier to see.
Assemble the tinted parts 82D, 82E and 82F as shown if you wish to use them.
Pic 2: Retrieve the door from stage 4.
Pic 3: Remove the screws holding the outer cover highlighted.
Do not lose the screws as the outer cover will be fitted to the tinted windows.
Pic 4: Whichever window option you choose, the 2 x screws currently holding the window in place are replaced with 2 x TM screws.
Pic 5: Fix the hinges 82B to the door using 2 x CM screws.
Pic 6: Fix the strap 82C to the inner frame 82A with 1 x ABP screw.
Pic 7: Store the parts safely for now.
roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
