|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,509 Points: 16,679 Location: ipswich
|
STAGE 87:
Right door window and hinges.
Pic 1: Press-fit the window parts 87A and 87B together.
The parts will only fit one way.
Pic 2: Retrieve the door from the previous stage and fit the window in place on the inside as shown.
Fix with 1 x ACM screw.
Pic 3: Retrieve the hinge bracket 86C from the previous stage and locate the hinges 87D and 87E.
Pic 4: Fit the top hinge 87D in the position shown and fix with 1 x BM screw.
Make sure the screw is fully tightened or it will foul the inner door panel later on.
Pic 5: Fit the bottom hinge 87E in the position shown and fix with 1 x BM screw.
Make sure the screw is fully tightened or it will foul the inner door panel later on.
Pic 6: Fix the hinge assembly inside the door 86A using 2 x BM screws.
Store safely for now.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,509 Points: 16,679 Location: ipswich
|
STAGE 88A:
Right door lining and fitting.
Pic 1: Press-fit the lock 88B into the end of the door lining 88A.
It will only fit one way.
Pic 2: Retrieve the door 86A and fit the strap 88C over the two posts as indicated.
Pic 3: Wriggle the door lining over the hinges and press it firmly into place on the door shell.
Pic 4: Retrieve the partition assembly 79D and remove the air intake support indicated.
Do not lose the screws.
Pic 5: Part removed.
Pic 6: Fix the door in place as shown using 4 x AM screws.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,509 Points: 16,679 Location: ipswich
|
STAGE 88B:
Pic 7: Fit the door and partition in place as shown making sure the bottom of the silver partition is sitting flat on the body frame.
Pic 8: Holding the door in place, carefully turn the model over and fix the partition using 2 x AM screws.
Pic 9: Re-fit the air pipe support previously removed.
Pic 10: Remove and discard the pipe indicated.
Pic 11: Fit the new pipe 88D and feed it through the front sidewall.
Connect it to the brake caliper.
Pic 12: Route the other long pipe on the gold fitting through the front sidewall as indicated and connect it to the brake caliper.
Store the model safely for now.
roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
