|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,232 Points: 22,003 Location: Northamptonshire, England
|
Issue 69
Picture 1 shows the contents of this issue.
Right Shin Guard
Retrieve the left shin guard from issue 4. Lay the straps as shown in picture 2 with the longer strap to the top.
Now place the mounting plate over the straps and secure in place using 2 x LP screws, picture 3.
Note:The magazine instructs you to attach the assembly onto the right leg. In the next stage it will instruct you to remove it again, so I would leave it off for the time being.
That completes the assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,232 Points: 22,003 Location: Northamptonshire, England
|
Issue 70 Part 1
Picture 1 shows the contents of this issue.
The Left Wrist Joint
Tip: Before we start with the next section, I would recommend using a pair of sturdy pliers to compress the spring. This will make it easier to fit into the part into the housing.
Insert the shaft into the joint base, whilst simultaneously inserting the shaft pin, pictures 2 and 3.
Slide the spring onto the rod and insert the assembly into the base joint as shown in picture 4.
Attach the base cover to close the assembly using the nut and 2 x HM screws as shown in picture 8. Use the wrench that was provided in issue 7 to tighten the nut, picture 5.
Place the wrist joint assembly into the forearm cover as shown in picture 6, then place the support cover and secure it in place using 3 x UP screws, picture 7.
Attach the wrist joint to the left forearm and secure it in place using 4 x KP screws, pictures 8 and 9.
That completes the assembly for part 1 of this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,232 Points: 22,003 Location: Northamptonshire, England
|
Issue 70 Part 2
The Left Wrist Joint
To make sure the shoe assembly fits easier it is recommended to remove the shin guards.
This next section is quite difficult to do and requires the assistants of another person. Lay the two shoes out next to the legs and position them accordingly, picture 10. Take one of the shoes and with one person positioning the shoe between the ankle protrusions, holding the leg and applying upward pressure to align the holes, get the other person to thread the screw. This will make it easier to insert the hexagonal screw, pictures 11 and 12.
On the other side of the screw, place a flat washer and spring washer over the thread and secure it with the nut using the wrench to tighten it up, picture 13.
Now do the same with the other shoe, picture 14.
Picture 15 shows the complete assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest (2)
|
US
