|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,721 Points: 17,315 Location: ipswich
|
STAGE 92:
Rear lights.
Pic 1: Connect cable 92A (10) to cable 10 exiting the rear right light aperture on the body.
Pic 2: Fix the wire to the body as shown with tab 92C and 1 x AP screw.
Pic 3: Retrieve the rear bumper assembly from stage 1 and carefully undo the fixing clips indicated.
Pic 4: Remove the rear bumper.
Pic 5: Fit the LED panels 92B as shown and fix the wires with 2 x tabs 92C and 2 x KM screws.
Pic 6: Cover the rear of the LED panels using 2 x strips 92D.
Pic 7: Connect the wires and plugs as shown.
Pic 8: Feed the plugs and wires back into the light aperture and then fix the rear panel in place with 3 x DM screws.
Pic 9: Press-fit the rear bumper panel back in place.
Store safely for now.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,721 Points: 17,315 Location: ipswich
|
STAGE 93:
Front lights.
Pic 1: Fit the grille 93B to the front panel 93A.
Pic 2: Fix from behind with 2 x BP screws.
Pic 3: Fit the 4 x front lights 93C.
Each clear lens has a small raised dot – highlighted in red.
This must be at the top.
Pic 4: Fix from behind with 2 x BP screws in each light.
Pic 5: Fit the LED wire 93D as shown with the plug on the right.
Pic 6: Fit the lower LED cable 93E as shown with the plug on the right and the LED’s passing through the holes in the lower panel.
Pic 7: Store safely for now.
roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
