|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,738 Points: 17,366 Location: ipswich
|
STAGE 97:
Lower side valance.
Pic 1: Holding the passenger door open carefully, fit the valance 97A in place making sure the front and rear ends are tucked inside the body.
Fix in the door step with 2 x NM screws.
Pic 2: Peel the backing from the tread plate 97B and stick it in place where shown.
Make sure the ‘DMC’ is the right way up.
Store safely for now.
roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,738 Points: 17,366 Location: ipswich
|
STAGE 98:
Power coil lighting.
Pic 1: Remove the tape from the LED.
Pic 2: Use a piece of tape 98G to wrap around the LED and the 2 x clear filaments 98F.
Make sure the ends of the filaments are in contact with the LED.
Pic 3: Locate the power box parts 98A (L) and 98B.
Pic 4: Fix the filaments and LED into the box 98B with the bracket 98A and 2 x IP screws.
Pic 5: Fix the box to the front of the car as shown using 1 x KM screw.
Pic 6: Press the cover 98C in place and fit the filaments into the brackets as shown.
Pic 7: Connect the other ends of the filaments to the LED on the other side.
Pic 8: Fix the power box in place as before and fit the filaments into the brackets on that side.
Store the car safely for now.roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
