Issue 34 - Contains the left-hand upper & lower engine cover's and gold reflectors; and has instructions for preparing and attaching the gold reflectors to the injector unit.
Preparing the gold reflectors - Turn both face down and gently rule pencil lines on the reverse surface 10mm from each end of the white backing paper.
Take a reflector between your fingers and thumbs and gently wrinkle and twist it at a point about a third of the way along the strip.
The metallic strip will gradually soften and start to separate from its backing paper.(Make sure the ends that you marked remains firmly in contact with the backing paper).
Work your way slowly along the reflector, wrinkling the surface until the whole of it is crumpled and starting to separate from its backing paper - apart from the ends you marked.
Repeat the process with the second reflector strip, then carefully cut both strips along the two pencil lines.
Attaching the reflectors to the injector unit - Take the injector unit that you assembled in issue 33, and check the positions of the gold reflectors. They go on the flat areas of each side, so that they fit between the two rounded ends and just below the red line.
Peel off the backing paper and gently place the gold foil in position, lining it up as mentioned, gently press the foil into place, taking care not to smooth out the wrinkled/crumpled effect.;
Use scissors or a very sharp blade to very carefully slice away any surplus foil beyond the edge of the injector unit moulding, then repeat the process with the second reflector on the opposite side of the unit.
That's it for this week, carefully store the assembly.
Future issues:Issue 35 - Contains the right-hand upper and lower engine cover; and has instructions for Stage 2 of the engine covers.
Issue 36 - Contains the underbody, panel covers and flip-up supports, and has instructions for Stage 1 of assembling the underbody -Preparing the left and right panel covers, attaching the panel covers to the underbody.
Issue 37 - Contains the left & right rear skirt and rear underbody panel, and has instructions for Stage 2 of the underbody - Attaching the rear underbody panel.
Issue 38 - Contains the left and right gearbox cowl supports; and has instructions for attaching the gearbox cowl supports.
Tomick attached the following image(s):