Stage 19 - Contains short & long planks, chamfered moulding, and anti-aircraft gun parts.
Don't forget to chamfer the bottom edge of the planks where necessary and to glue each plank along its full length to the next as well as to the frames.
Take a short plank and cut a piece so that it sits edge-on between frames 12 and halfway across frame 13, then glue into place.
Take the chamfered moulding, this is fits across the frame slots of 13 to the middle of frame 19, the moulding should be placed with its angled edge facing outwards and upwards as shown in the steps, cut to length then glue the moulding in place.
Run a short plank to fit from frame 12 to the middle of frame 17 so that it fits at the bottom of the frames against the bottom plate, cut it to length, chamfer its bottom edge, and glue into place.
Take a short plank and locate above the previous plank, so that it runs from frame 12 to the middle of frame 16, cut to length and glue into place, then repeat with another plank.
Take another short plank, place above the previous, this time so that it runs from frame 12 to halfway across 17, cut to length and glue into place, then repeat with a second plank.
Take a long plank, and fit above the chamfered moulding so that it runs from frame 14 to halfway across frame 19, cut to length and glue into place.
Take a long plank, start it behind the bow frames located on the deck in front of frame 13, and run it to halfway across frame 18 and cut to length. When gluing this plank in place it should sit approx 1mm above the frame shoulder's, but do not glue it to the bow deck frame.
Take a long plank, and fit it from frame 14 to frame 19 and is located above the plank above the moulding, cut to length and glue into place.
Take a long plank and fit above the previous plank so that it runs from frame 14 to halfway across frame 18, cut and glue into place, then repeat with a second plank.
Identify the planking gaps and fill these area's as before using the remaining planking.
Issue 20 repeats the hull planking from this issue on the opposite side of the hull.
Anti-aircraft gun - assemble and paint as per the previous gun.
Future stages: Stage 20 - Contains short & long planks, chamfered moulding and an A6M Zero aircraft kit.
Stage 21 - Contains the portside stern deck plate, planks and a deal sheet.
Stage 22 - Contains the starboard stern deck plate, an anti-aircraft gun and platform
Stage 23 - Contains planks, chamfered moulding, boat (hull & deck), rails and diecast parts.
Tomick attached the following image(s):