downloaded the template it says print at 100% it either comes out too small or to big [ im using HP Deskjet F4280 all in one] so right now this template is as usefull as choclate tea pot. Any sugestions on how to get the right size would be apreciated
Andy

Hi Budgie
and thanks for the reply/advise having tried nearly all you sugest [didnt think about the american resizing ] i spent the afternoon resizing the thing on my pc. i think i got it right now, il be posting pics in my diary tomorrow. I just hope the full size plans are sent as part of the subscription and not a download as i can see problems there aswell
regards
Andy

Hi Brian
this is how i did it,i measured on the bridge from the flag deck to ladder deck position no2[ the deck thats between the double rangefinders on port and starboard]its 20/21mm i think from memory. i then used picture resising software till i got the template to match the measurment i had, abit long winded to do but it worked for me.
Also il mention the templates downloaded for the rear boat decks same problem again printed out at wrong size but deag kindly sent me some that they had printed out and that did the trick [ please feel free to look at my build diary for a handy tip with an iron when you get to this stage].
One other thing to mention you will get downloads of both side elevations of the hull and the hull shaping templates[two are missing on the download by the way]but if your in no hurry all are sent as hard copys about 2/3 months after the download. Hope this helps and how about a few pics of your build
regards
Andy