|
Rank: Vice-Master Groups: Registered
Joined: 20/04/2010 Posts: 545 Points: 1,536 Location: lossiemouth
|
centering holes in the end of mast and small stanchions trickey try this brass tube of various sizes slip in to each other so fit tube diameter of drill to.tubes about 25millmeters long up to the outer diameter of mast/stachion slip it over insert drill dead on centre
|
|
Rank: Pro Groups: Registered
Joined: 30/03/2010 Posts: 285 Points: 880 Location: Belton, Norfolk
|
Sorry chap you've lost me on that one Any chance of explaining it again but in laymans terms
I wish I were a glow worm, A glow worm's never glum, 'Cause how can you be grumpy? When the sun shines out ya bum!!
|
|
Rank: Pro Groups: Registered
Joined: 30/03/2010 Posts: 143 Points: 434 Location: cheshire
|
i could be wrong!!! but i think he's trying to say incert 1 tube within another and another till you have the requierd drill bit size then slip it over the end of the mast or spar and then the drill bit will be dead central Alan
|
|
Rank: Vice-Master Groups: Registered
Joined: 20/04/2010 Posts: 545 Points: 1,536 Location: lossiemouth
|
captainalan spot on, try it in a model shop brass tubes slide in to each other like a telescopic aerial old aerial from car etc will do cut down to required size another tip boreing holes in the hull of a boat holes are ovel centers miss leading find centre of shaft hole etc bore hole to fit smallest tube insert tube next tube that slips over cut end with snips to look like hole saw slip over first tube twist and drill, tube will drill through donot remove , next tube the same till required diameter is reach i have dont this with a bow thruster on a supply boat and a stern tube on a fishing boat cutting the round shaped keel very neatly
|
|
Rank: Pro Groups: Registered
Joined: 22/03/2010 Posts: 369 Points: 1,150 Location: Broadstairs
|
Excuse my ignorance, but why do we need to drill holes in the centre of the masts. Completely lost on that one? TIS
|
|
Rank: Vice-Master Groups: Registered
Joined: 20/04/2010 Posts: 545 Points: 1,536 Location: lossiemouth
|
Tiswas wrote:Excuse my ignorance, but why do we need to drill holes in the centre of the masts. Completely lost on that one? TIS dont know about this model yet but if it is like the bounty kit i am building you drill up the mast to fit boom guides hoops brasswire
|
|
Rank: Pro Groups: Registered
Joined: 30/03/2010 Posts: 285 Points: 880 Location: Belton, Norfolk
|
Ok yep got it now simples Thanks willie and captainalan
I wish I were a glow worm, A glow worm's never glum, 'Cause how can you be grumpy? When the sun shines out ya bum!!
|
|
Rank: Pro Groups: Registered
Joined: 22/03/2010 Posts: 369 Points: 1,150 Location: Broadstairs
|
Thankyou for that willie, will figure it out in time. It's the way you tell em. TIS
|
|
Guest
|