|
|
|
|
 Comming along nicely m8  Current builds:-C57,Zero, Lamborghini Countach, Caldercraft HMS Agamemnon,Robi,R2-D2, MFH Cobra .
|
|
|
 Rank: Super-Elite      Groups: Registered
Joined: 24/04/2010 Posts: 5,787 Points: 17,662 Location: Stafford, United Kingdom
|
Hi Bob I like your work Good stuff Regards Mike  MWG BUILD DIARIES: HMS VICTORY, SOVEREIGN OF THE SEAS, SAN FRANCISCO II, HMS HOOD, HMS ENDEAVOUR LONGBOAT, HMS VICTORY X-SECTION, 007 DB5, NISSAN GTR, CUTTY SARK, RB7, AKAGI, BARK HMS ENDEAVOUR, HUMMER H1, MITSUBISHI ZERO.
|
|
|
 Rank: Vice-Master   Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
thanks mike and andy Come on you Jimmies
|
|
|
Rank: Vice-Master Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
i have now fitted the mizzen booms and sail, but can't finish rigging it as the magazine leaves the last bit until later. i had a few problems with the lanterns as i misplaced them. i have now found them and should be fitting them later today. when fitting the lanterns make sure you get the correct diameter drill bit, the magazine says to use a 1mm bit but when i measured the lantern posts they were 1.4mm and 1.2mm so make sure you check before drilling. i'll be starting the bowsprit yards next, but from reading the magazine there are more holes to be drilled in the bowsprit, anyone who is at the bowsprit stage should maybe look at the official build for issue 104 and drill these holes before fitting the bowsprit. i've noticed a few steps in the recent magazines that seem to take us back to alter/add new steps to work done in previous issues. such as increasing the size of the pinrail bitts, and altering some blocks which have already been fitted, so make sure you read ahead, one to look out for is where the heart blocks are fitted to the main mast, as the actual length of thread is altered at a later stage. Come on you Jimmies
|
|
|
 Rank: Pro Groups: Registered
Joined: 07/01/2011 Posts: 399 Points: 1,212 Location: Penhill Estate, Western Cape, ZA
|
Good work Bob, I hope you locate those missing lanterns.
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
saintsman123 wrote:i have now fitted the mizzen booms and sail, but can't finish rigging it as the magazine leaves the last bit until later.
i had a few problems with the lanterns as i misplaced them. i have now found them and should be fitting them later today.
when fitting the lanterns make sure you get the correct diameter drill bit, the magazine says to use a 1mm bit but when i measured the lantern posts they were 1.4mm and 1.2mm so make sure you check before drilling.
i'll be starting the bowsprit yards next, but from reading the magazine there are more holes to be drilled in the bowsprit, anyone who is at the bowsprit stage should maybe look at the official build for issue 104 and drill these holes before fitting the bowsprit. i've noticed a few steps in the recent magazines that seem to take us back to alter/add new steps to work done in previous issues. such as increasing the size of the pinrail bitts, and altering some blocks which have already been fitted, so make sure you read ahead, one to look out for is where the heart blocks are fitted to the main mast, as the actual length of thread is altered at a later stage. Thanks for the heads up on these points, if you dont mind me adding, the cannon balls and some of the pins could be added when constructing the garlands /pinrails before gluing in their final places, as you have said keep a good eye on the official build and anyone that may be ahead of your own build. Good diary, Steve..
|
|
|
Rank: Vice-Master Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
thanks steve ype your right about the cannonballs, it's much easier to do them at the time than try and fiddle about with them when the parts are on the model. anyone who has read son of bulwarks diary can see there looks as though there is a problem with the staysails, i thought we would hit some trouble at this point, especially as the official build is going bare spars. please note this is not a complaint about tomicks wonderful diary and the advice he gives. i felt a while a go, that for us who have choosen sails we would be going into this stage blind, with only the magazine for guidance. i know it would be too much work for anyone, let alone the wonderful mrt. to provide a double diary, with stained and painted, bare spars and sails, but as we have seen before there are a number of small errors in the magazine regarding typo's, which tomick has been able to clear up for us, but i feel this could be more than just a slight typing error. i know darron has pm'd tomick about the problem so it's a case of waiting for an answer. for once i am not going to go off on one of my rants, mainly because i'm off to scotland in the morning for a bit of a break, so am in no hurry for a reply, as i will not be able to do anything on victory for a week. so happy easter to everyone, and i hope it's all sorted when i get back, a week with no modelling  and no internet ,........how will i survive. Come on you Jimmies
|
|
|
Rank: Vice-Master Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
some up to date pictures saintsman123 attached the following image(s): Come on you Jimmies
|
|
|
 Rank: Elite   Groups: Registered
Joined: 22/03/2010 Posts: 2,065 Points: 6,295 Location: Gorleston-on-sea
|
You have done a cracking job there Bob... Current Builds: Deagostini HMS Victory: Deagostini HMS Sovereign of the seas. Completed Builds: Del Prado: HMAS Bounty: Hachette: RMS Titanic: Del Prado: Cutty Sark...
|
|
|
Rank: Super-Elite Groups: Registered
Joined: 24/04/2010 Posts: 5,787 Points: 17,662 Location: Stafford, United Kingdom
|
Hi Bob Thats a smashing build Regards Mike MWG BUILD DIARIES: HMS VICTORY, SOVEREIGN OF THE SEAS, SAN FRANCISCO II, HMS HOOD, HMS ENDEAVOUR LONGBOAT, HMS VICTORY X-SECTION, 007 DB5, NISSAN GTR, CUTTY SARK, RB7, AKAGI, BARK HMS ENDEAVOUR, HUMMER H1, MITSUBISHI ZERO.
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Nice work Bob
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Thats one very good looking build
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Hi Bob! You’ve done a lot of work there mate! looks good seeing all those sail, only I spotted something that you might want to take a look at. I've sent a PM to explain. Darron
|
|
|
Rank: Pro  Groups: Joined: 04/05/2012 Posts: 362 Points: 1,089
|
Your Victory looks very good Bob
|
|
|
Rank: Vice-Master Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
thanks shipmates darron spotted an error, but have resolved it now, i put the martingale stays through the wrong holes in the dolphin stiker.............i thought it looked odd. thanks darron Come on you Jimmies
|
|
|
 Rank: Amateur Level 1 Groups: Registered
Joined: 06/03/2011 Posts: 34 Points: 98
|
Coming on nicely Bob.
I'll pop round when i get back home.
|
|
|
Rank: Pro  Groups: Registered
Joined: 29/03/2010 Posts: 190 Points: 512 Location: Lytham UK
|
Hi Bob.. The Victory build is looking great. Best regards, Ian Ian Builds in progress: E-type, HMS Victory, HMS Endeavour, HMS Soverein of the Seas Wish list: Bentley Blower http://forum.model-space...spx?g=posts&m=30439
http://mxpublishing.co.uk/engine/shop/product/9781780920184/Hunt+for+the+Blower+Bentley
|
|
|
Rank: Super-Elite  Groups: Registered
Joined: 16/08/2010 Posts: 2,771 Points: 8,344 Location: Brighton
|
hi Bob. looking fantastic, looking forward to seeing some more pictures ian Current builds.Hachettes build the bismark,HMS Victory, HMS Hood.
Finished Builds Corel HMS Victory cross section.
|
|
|
Rank: Pro  Groups: Registered
Joined: 11/09/2011 Posts: 227 Points: 677 Location: Heidelberg South Africa
|
Hi Bob That's just stunning Current Buid:
HMS Victory
Next Build:
Captain Cook's Endeavour Collecting issues
Wish List:
Santa Ana
Bounty
Santisima-Trinidad
|
|
|
 Rank: Master  Groups: Registered
Joined: 30/03/2011 Posts: 1,344 Points: 4,079 Location: Bryanston, Johannesburg. RSA
|
That is one magnificent build you have there. Well done. Rgds, Hans
"It's okay to make mistakes. mistakes are our teachers - they help us to to learn, even if it is painfully"
Current Build:
Endeavour Cross section,D51
Completed: HMS Victory
Under the bench: Endeavour x 2,Sovereign of the Seas, Akagi and The Black Pearl!HMS Victory Cross Section
|
|
|
|
Guest (9)
|
US
