|
|
 Rank: Pro   Groups: Registered
Joined: 28/04/2013 Posts: 158 Points: 486 Location: England Cheshire
|
When I got round to rigging the deadeyes on Victory, I found problems using the wire jig. My solution was to make up a jig from brass wire and a piece of scrap plank. Measure across any two holes in a deadeye mark out on the piece of plank. Drill 4 0.6mm holes Bend the brass wire as per the magazine, leaving longer tails, feed the wire through the holes and secure with super glue, bend the wire as needed and trim to length. Repeat for small deadeyes.
|
|
|
 Rank: Amateur Level 1 Groups: Registered
Joined: 21/08/2010 Posts: 35 Points: 110 Location: Now in Berlin, Germany
|
 HI, I would be very grateful if you could try to put images to your suggestion as it would be easier to get 'a picture'. It sounds interesting but I just don't get it... thanks.....
|
|
|
Rank: Pro Groups: Registered
Joined: 28/04/2013 Posts: 158 Points: 486 Location: England Cheshire
|
Skipper, I have uploaded a couple of photos.
|
|
|
|
Guest (2)
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
