|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
To John Passmore.
HI John, I could not get a connection to your post #145 thru the Forum search facility, so could you describe your procedure in just a few words?? Regards, Peter G
|
|
|
Rank: Pro     Groups: Registered
Joined: 25/04/2014 Posts: 370 Points: 1,122 Location: Mandurah W.Australia
|
Peter G wrote:To John Passmore.
HI John, I could not get a connection to your post #145 thru the Forum search facility, so could you describe your procedure in just a few words?? Regards, Peter G Hi Peter Where you have drawn the square for the gunport, drill a vertical row of small holes (0.4 - 05mm) just inside of each vertical of the square. Drill them as close together as possible, then you can cut through each hole quite easily with a craft knife, starting at the top and drawing the knife down...  Following that you just cut the horizontal top and bottom, then it's just a matter of file/sand back to the drawn lines...  Trust this clarifies... Kind regards JohnP
|
|
|
|
|
Hi Peter, this link to John's post on cutting gun ports may help... http://forum.model-space...sts&t=11368&p=8
Regards Alan
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
HI John, Alan, all is even clearer now. Thanx again! Peter G
|
|
|
|
Guest (2)
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
