|
|
 Rank: Newbie Groups: Registered
Joined: 31/01/2017 Posts: 1 Points: 3 Location: London England
|
I have a problem with extrude motor.
when the extruder reaches 200 degrees, I go to manual control to test the extrude tab. the motor is working but there is a clicking sound and is unable to turn the gears.
when I use my finger to turn the gears there is no stiffness and the filament moves back and forth through the extruder arm very well.
could this be a faulty motor?
|
|
|
Rank: Administration        Groups: Registered, Forum Support Team, Administrators, Global Forum Support Team, Moderator, Official Builds Joined: 09/11/2012 Posts: 7,970 Points: 23,099 Location: East midlands
|
nick3d wrote:I have a problem with extrude motor.
when the extruder reaches 200 degrees, I go to manual control to test the extrude tab. the motor is working but there is a clicking sound and is unable to turn the gears.
when I use my finger to turn the gears there is no stiffness and the filament moves back and forth through the extruder arm very well.
could this be a faulty motor? Hi Nick,  I`ve just checked in the official build and was wondering if you set the gears for the extruder motor as per stage 53, with the piece of paper to give the correct gap between the gears. Regards delboy271155 (Derek) COME BACK GUY FAWKES "YOUR COUNTRY NEEDS YOU"
|
|
|
|
|
Hi Nick Could you provide a couple of pictures of the parts that are not working, dont strip them down just in place for now please. Andy Current builds:-C57,Zero, Lamborghini Countach, Caldercraft HMS Agamemnon,Robi,R2-D2, MFH Cobra .
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
