Issue 13 - Contains front & rear wheel spacers; and has instructions for attaching the front spacers to the front wheel rims and fitting the front tyres.
Separating the wheel spacers - The wheel spacers are supplied in pairs joined by four sprue's.
Take the two front pairs (stamped F), and separate each pair by cutting the sprue's close to the sides of the spacers, being careful
NOT to cut the projecting pins between the sprue's.
You should end up with two spacers, each with two pins sticking out, repeat for the other pair of spaces but do not mix the two sets.
Attaching the spacers to the wheels - Take one of the front wheel runs and half a wheel spacer, fit the spacer over the wheel with the pins touching the raised edge of the rim at the spoked side.
Inject one drop of liquid superglue through one of the holes in the spacer, which should flow along the groove in the back of the spacer, turn the wheel so that the glue runs along the groove, and then put another drop into the same hole.
Repeat this for the other hole in the spacer, then repeat the whole process to make sure the glue spread thoroughly. Ensure the spacer does not move until the glue sets, then glue the other spacer to the other side of the wheel in the same way.
Finally, cut-away of the four temporary spacer pins as close as possible to the spacers, then repeat these steps to add the spacers to the other wheel rim.
Fitting the tyres onto the wheels - Take the left front tyre (from issue 2) and the right front tyre (from issue 5).
You can tell the inside and outs side face of the tyres by the shape of the bead on the inner rim of the tyre, - The outside face has a bead a step, whilst the inside face has no bead step, also the white triangles on the outside face should point in the direction that the wheel will rotate when the car is going forwards.
Match up the outside face of either tyre with the spoked side of a front wheel rim, align the 'E' in BRIDGESTONE' with the space between the name 'ENKEI' and the logo on the wheel rim, then push the rim firmly into place.
Check that the tyre is fully seated into the groove formed between the wheel rim and spacer on the outside, and that it is sitting evenly on the wheel on the inside, repeat the process for the other front tyre and wheel rim.
That's it for this issue, place the wheels into bags for protection and carefully store the rear wheel spacers.
Future issues:Issue 14 - Contains the rear wing upper & middle and separator, plus top camera; and has instructions for preparing and the assembly of the rear wing parts.
Issue 15 - Contains the rear wing base, stays and fins; and has instructions for preparing the parts and gluing the wing stays & fins to the wing base.
Issue 16 - Contains the rear wing end plates and lowers; and has instructions for gluing the rear wing lowers to the wing base and attaching the wing end plates.
Issue 17 - Contains Left/Right rear brake ducts, outer/inner uprights & holders, and screws; and has instructions for the assembly of these parts which make up the rear brake units.
Tomick attached the following image(s):