|
Rank: Newbie Groups: Registered
Joined: 13/04/2017 Posts: 2 Points: 6
|
I am not sure if I did something wrong when fully finishing the z axis or (table). However when I am trying to calibrate it using the pack 11 guide. It only moves down halfway when I press the home button on the icon. This problem has arisen when calibrating using pack 11 guide, pg 288 #3. Can you give me some advice as to what I can do to fix this problem and continue the calibration process? Thanks
|
|
Rank: Super-Elite Groups: Registered
Joined: 17/12/2013 Posts: 3,982 Points: 11,974 Location: NY, USA
|
Hi sterling1977, I am forum support for USA.Can you take a picture of where the table ends up after you press the home button.Can you manually move the table lower if you use the controls in Repetier host.Have you checked the connection for the z axis limit switch?
CaRL
|
|
Rank: Newbie Groups: Registered
Joined: 13/04/2017 Posts: 2 Points: 6
|
I am not sure how to manually calibrate the table using the program. So I am still unsure as to how to proceed in the calibration process. I tried using repetier to manually move it down, but it just buzzes when I attempted to move the table manually and of course the table does not move?
|
|
Rank: Super-Elite Groups: Registered
Joined: 17/12/2013 Posts: 3,982 Points: 11,974 Location: NY, USA
|
Please reply to my PM regarding this issue
Carl
USA forum support
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.