|
|
 Rank: Vice-Master     Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
How important are the positioning and spacing of the 0.7mm holes as at step 2 page 12 (issue 61)? The reason I ask is that one of the holes is drilled 24mm from the outside, and (due to tolerances I assume) the edge of the inside space is 25mm from the outside,if I drill the hole at 24mm I am worried it may be too close to the edge. Come on you Jimmies
|
|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Have checked with the design team, the hole is in fact close to the edge and it is important the spacing is as per that shown, though the photo which relates to the 24mm hole has a minor discepency in showing the hole further in from the edge than where it actually falls, and should be closer to the edge.
So to recap, the measurements are correct and maintain the spacing shown.
|
|
|
Rank: Vice-Master Groups: Registered
Joined: 30/01/2011 Posts: 865 Points: 2,410 Location: Cambs
|
Thanks for that  Come on you Jimmies
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
