|
|
 Rank: Pro   Groups: Registered
Joined: 30/11/2017 Posts: 493 Points: 1,482 Location: South Norfolk
|
Ahoy Shipmates, I just completed issue 83 and checked the die-cast parts which will be painted and fitted in issue 90. Unfortunately one of the spears is slightly bent on the trophy. Could anyone suggest a method to bend it back? As the die-cast part is very brittle I don't want to "just" bend it and risk to snap. Any suggestions? Or shall I ask Customer Service to send a replacement part? Thanks. gingerale75 attached the following image(s): Happy building! Laszlo Finished builds: HMS Victory, HMS Victory Cross-Section
|
|
|
 Rank: Super-Elite     Groups: Registered
Joined: 19/06/2013 Posts: 4,588 Points: 13,553 Location: West Yorkshire
|
gingerale75 wrote:Ahoy Shipmates,
I just completed issue 83 and checked the die-cast parts which will be painted and fitted in issue 90.
Unfortunately one of the spears is slightly bent on the trophy.
Could anyone suggest a method to bend it back? As the die-cast part is very brittle I don't want to "just" bend it and risk to snap.
Any suggestions? Or shall I ask Customer Service to send a replacement part?
Thanks. Safest way would be to ask Customer Service to send a replacement part. Whilst you await its arrival you could always try to straighten it by bending it after some gentle heat application. Al
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
