Hi All
At some point during my build I must have made a basic mistake which has caused my mizzen mast to be about 1.5 mm off the vessels center line.
When I ensure the 8mm dowel fits into the mizzen mast hole, and goes all the way to the bottom, you'll find it easier to insert if you sand a bevel on one end. (as per MR T's Official build instructions)
The mast is not vertical and is offset see photos

.

My solution will be to ease the mast holes in the quaterdeck support and lower gun deck holes together with a cut out on the lower part of the mast.
The fore mast is correct but the main mast will require a very slight adjustment.
Any comments about my solution, a better one etc, will be appreciatd.
I would also like to know where I have gone wrong if possible.
First Build HMS Victory and HMS Endeavour
Also Krick steam boat "Victoria"
Cheers
Ivan (Ordinary Seaman)
http://www.old-glossop.com