|
|
|
Rank: Member
Groups: Registered
Joined: 26/11/2017
Posts: 10
Points: 30
|
Hello guys, i have question about it  in instruction is 19 mm what it if i have more then 20? i should flush it?
|
|
|
|
|
Have a look here at Stage 31 of the Official Build, it explains about adjusting the bulwark heights.... https://forum.model-spac...aspx?g=posts&t=1573
At this stage of the build the 19mm height you are quoting is the minimum height you need to have, heights will all be adjusted later in the build.... Hope this helps Alan
|
|
|
|
Rank: Member
Groups: Registered
Joined: 26/11/2017
Posts: 10
Points: 30
|
i found it
"Now measure the height of the bulwarks at frame 22, it should be at least 19mm above the top deck support bracket, use the same process to raise the height of the bulwark if necessary."
but nothing about if is more like 20 mm. Then leave it for now, and continue ?
|
|
|
|
|
gidaban wrote:i found it
"Now measure the height of the bulwarks at frame 22, it should be at least 19mm above the top deck support bracket, use the same process to raise the height of the bulwark if necessary."
but nothing about if is more like 20 mm. Then leave it for now, and continue ? Yes, leave it for now as advised in the Official build here: Adjusting the height of the Bulwarks
Check the height of the completed planking around the forecastle and quarter deck, if necessary you may need to add extra strips to ensure that the planking finishes at the correct level, (don't worry if any bulwarks are higher than quoted, they are sanded to the exact size later, after the internal planking is added).Regards Alan
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
