Hi all thanks for the comments.

So P2 Step 1, Add the last three ribs to the stern area.



Step 2, Add the three rear stern sections and a small side piece.

Stage 6-7 is just to cut a small piece of the bottom of the last rib.



Stage 8 was to add the first lot of planks to the rear of the model, but I forgot to take a photo sorry.

Stage 9 build a little shaping unit.



This is used to help shape the transom.

Step 10 shaping the transom.

Looks good, considering its size.

Well done so far.


Regards
delboy271155
(Derek)

Step 16 Finish adding the planks.







Thats page 2 done.

Page 3 no not that type Stage 1 Just sand down the outer planks.

Stage 2-10 Was to install the transom parts, your meant to use the small jig but personally its a waste of time. I just glued each piece in turn to the frame work on the ship.



I've also sanded down the top parts as they where in the way of the clamps and would need to be removed later anyway.

Stage 11. Sand down the inner ribs.



Stage 12. Add some more darker planks.



Stage 13-14. Add the lower deck section.




For each if the decks they give you a piece of ply to hold up against the frame work to show where the decks should go.

Page 4.




Stage 1-2, install the second deck.

This is look fab and a very interesting build to follow.... Very well done.....

Regards

Alan

Looks excellent, very nice work.

Mark

Stage 3-4 Installing the next deck.