|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,345 Points: 16,187 Location: ipswich
|
STAGE 15:
Left rear swing arm.
Pic 1: Locate the arm 15-2, bracket, 15-3 and screw ‘F’.
The parts fit together in the order shown.
Pic 2: Parts assembled.
Pic 3: Locate the arm 15-1, 2 x brackets, 15-3 and 2 x screws ‘F’.
The parts fit together in the order shown.
Pic 4: Parts assembled.
Pic 5: Retrieve the assembly from stage 14 and fit the arm 15-2 as shown.
Fix using 1 x ‘G’ screw.
Pic 6: Fit the other arm 15-1 to the other end of the hub, between the springs and fix with 1 x ‘G’ screw.
Pic 7: Shows the arm fitted (highlighted in yellow) from a different angle for clarity.
Store the assembly safely.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,345 Points: 16,187 Location: ipswich
|
STAGE 16:
Rear frame.
Pic 1: Fit the 2 x suspension bases 16-2 to the top of the frame 16-1 as shown and fix with 2 x ‘D’ screws in each.
Pic 2: Retrieve the hub assembly from the previous stage and fit it against the frame as shown.
The 4 x flexible brackets on the ends of the swing arms locate in the 4 x recesses on the frame.
This is quite fiddly so it is suggested you fix them as follows:
Pic 3: Position the arm 14-A first, ignoring the other three fixings for now.
Fix with 1 x ‘G’ screw.
Then position the end of arm 15-2, and fix with 1 x ‘G’ screw.
Pic 4: Position the ends of the ‘A’ shaped arm 15-1 in the locating holes and fix with 2 x ‘G’ screws.
Pic 5: From the other side, fix the tops of the dampers using 4 x ‘R’ screws.
Store the assembly safely.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,345 Points: 16,187 Location: ipswich
|
STAGE 17:
Right rear suspension.
NOTE: Steps 1 and 2 are missing from the printed instructions which only describe step 3 (pic 4 below) but they are detailed here.
Pic 1: Locate the lower arm 17-3 and bracket 17-4.
You will also need 1 x screw ‘F’.
The parts fit together in the order shown.
Pic 2: Parts assembled.
Pic 3: Fit the assembly to the bottom of 17-2, between the silver forks as shown.
Fix with 1 x ‘F’ screw.
Pic 4: Fit the hub 17-1 to the lower arm just fitted to the assembly and fix from below with 1 x ‘G’ screw.
Store safely for now.
roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
