|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,398 Points: 16,346 Location: ipswich
|
STAGE 3:
Brake disc and front wheel.
Pic 1: Disc 3A will fit onto disc 3b.
Peel the backing from 3A and stick it to the upper face of 3B.
Pic 2: Parts assembled.
Pic 3: From the other side, fit the disc centre 3C in place.
Pic 4: The parts are a very loose fit so it might be advisable to secure them for now with a piece of low tack masking tape.
This is at the builder’s discretion.
Pic 5: Parts assembled, from the other side.
Pic 6: Locate the tyre 3D and the rim 3E.
Pic 7: Soak the tyre in hot water for about 30 seconds.
Be careful with hot water.
Pic 8: Remove the tyre from the water with tongs and dry it inside and out.
Pic 9: Press the rim 3E into the tyre paying attention to the tread pattern as shown.
The wide grooves go on the side of the rim face.
Pic 10: Store all parts safely for now.roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
