|
|
Rank: Administration         Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,264 Points: 22,099 Location: Northamptonshire, England
|
Issue 104
Picture 1 shows the contents of this issue.
Hood Inner Reinforcement.
Place the hood latch 104 B on the outside of the hood in a reinforcement 104 A. Note there is only one way this will mount as the latch has one side longer than the other. Turn the assembly over and secure it in place using a PS31 screw as shown in pictures 2 and 3.
That completes the assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
Rank: Administration Groups: Registered, Administrators, Global Forum Support, Moderator, Forum Support Team, Official Builds Joined: 04/01/2016 Posts: 7,264 Points: 22,099 Location: Northamptonshire, England
|
Issue 105
Picture 1 shows the contents of this issue.
Hood
Place the inner reinforcement on the underside of the hood and make sure that the four protrusions on the hood fit snugly into the holes in the reinforcement. Fix the reinforcement to the hood with four DS35 screws as shown in picture 2.
That completes the assembly for this issue.
Markwarren attached the following image(s): Regards
Markwarren
(Mark) Admin
|
|
|
|
Guest (2)
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
