|
|
 Rank: Super-Elite        Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,855 Points: 17,717 Location: ipswich
|
STAGE 1:
Front face.
Pic 1: Fit the trim piece 1E to the bumper 1A as shown and fix from behind with 1 x PS21 screw.
Pic 2: Repeat at the other side with trim piece 1F.
Pic 3: Fit the centre trim 1D in place as shown.
There is a raised dot on the rear of the trim where indicated in yellow.
The trim fits this way round.
Pic 4: Fix from behind with 4 x PS21 screws.
Pic 5: From the inside, fit the indicator lenses 1K and 1L.
Pic 6: Fix the indicator housings 1G and 1H where shown using 2 x DS01 screws in each.
Pic 7: Assemble the light units 1J and 1N and 1M and 1I as shown.
The parts will only fit one way.
Pic 8: Fix the assemblies inside the bumper where indicated using 2 x DS01 screws in each.
Pic 9: Press-fit the red trim 1D to the grille 1B as shown.
Note the highlighted curved section which must be at the top.
Pic 10: Fix the grille to the bumper using 3 x DS02 screws from behind.
Pic 11: Press-fit the M3 badge in place as shown.
Pic 12: Store safely for now.roymattblack attached the following image(s):
|
|
|
Rank: Super-Elite Groups: Official Builds, Administrators, Moderator, Global Forum Support, Registered Joined: 04/06/2011 Posts: 5,855 Points: 17,717 Location: ipswich
|
STAGE 2:
First wheel.
Pic 1: Peel the backing from the badge 2J and fix it to the centre of the cap 2H.
NOTE – You may find the badge is already stuck in place.
Pic 2: Press-fit the valve 2I into the locating hole in the rim 2D.
Pic 3: Flex the tyre 2A and fit the 2 x inserts 2E as shown.
Pic 4: Press the 2 x joining clips 2F into place as indicated.
Pic 5: Fit the rim parts 2C and 2D together making sure the locating points on both parts line up.
Pic 6: Fix from the other side with 2 x DS08 screws.
Pic 7: Fit the mounting bolt ring 2G in place as shown.
Pic 8: Fit the assembly into one side of the tyre 2A.
Pic 9: Fit the inner rim 2D in place making sure the locating pins highlighted in blue are in line with the matching holes.
Fix the rim parts together with 4 x DS08 screws.
Pic 10: You can add the centre cap here but it will not yet stay in place so store it safely with the wheel.roymattblack attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
