Welcome Guest Search | Active Topics | Log In | Register

Cannon assembly Options
Previous Topic · Next Topic
Bob Abell
#1 Posted : 09 November 2012 20:48:16

Rank: Semi-Pro Level 1
Build-Diary Medal: Build-Diary Medal of Honour
Groups: Registered

Joined: 09/11/2012
Posts: 69
Points: 177
Location: Manchester
Looking at the photo in Issue 1.....Picture 10
The cross piece is partially blocking off the axle hole
I`m thinking of cutting a groove across to clear the axle?
Any other suggestions?

Bob
Back to top
 Report Abusive | Report SPAM
court orchard
#2 Posted : 09 November 2012 20:58:25

Rank: Master


Active Service Medal: 500 post active service MedalPurple Medal: Super active service medal for 1000 postsTurquoise Medal: Turquoise Medal for model making know-how contributionBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Registered

Joined: 05/09/2012
Posts: 1,400
Points: 4,690
Location: Beaminster, Dorset
Just lift it up 0.25mm, it's what I did.
Andy

Building:Samurai Armour, SOTS, Victory X-Section, Bismarck, D51
Finished:WW I Bavarian NCO, Caldercraft HM Bark Endeavour FFG 58 Samuel B Roberts,
Back to top
 Report Abusive | Report SPAM
Bob Abell
#3 Posted : 09 November 2012 21:18:12

Rank: Semi-Pro Level 1
Build-Diary Medal: Build-Diary Medal of Honour
Groups: Registered

Joined: 09/11/2012
Posts: 69
Points: 177
Location: Manchester
OK thanks Andy

Bob
Back to top
 Report Abusive | Report SPAM
Users browsing this topic
Guest (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.083 seconds.
DeAgostini