|
|
 Rank: Pro Groups: Registered
Joined: 05/12/2012 Posts: 258 Points: 754 Location: manchester
|
hi this might be a stupid question but in the official build why cut the heads off the rear three pins and not take them out 
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
You'll find that the magazine steps also say to leave the pin shanks in at the plank joints. Which is because these are week points which relate to bamboo planking as its not the most absorbant of wood types, where removing the pins can pull away the plank at the same time.
So its safer to snip off the head's and push in the shanks a little, so that when it comes to sanding the hull, the shanks do not interfere with the sanding as they are obviously much tougher than wood, where you may end up with high spots around the shank area.
|
|
|
Rank: Pro Groups: Registered
Joined: 05/12/2012 Posts: 258 Points: 754 Location: manchester
|
hi thanks mr t never worked with bamboo before only lime when i built the bounty a few years ago
|
|
|
Rank: Pro    Groups: Registered
Joined: 16/06/2013 Posts: 284 Points: 859 Location: Cape Town, South Africa
|
Pin head SizeHow do you identify the sizes of the pin heads when you order it online? My local hardware store's brass pin's head are much bigger than from the SOTS. "Rather try and fail than had failed to try".Sovereign of the Seas Model Space forum: Marcel's build
|
|
|
Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
|
|
|
|
Guest (2)
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
US
